Addonics Technologies HDU11SITDR Manuel d'utilisateur télécharger pdf

Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk.

For example, on the label of the hard drives, it might identify both drives as 80GB but the actual size

differs. And when this type of drives are used on the HDD duplicator, when you start duplicating, you will

receive a “Target Not Ready” error. To resolve this issue, you need to decrease the drive size of the

source drive. To do this, navigate to: 6.Setup > 6.2Copy Size and use the button arrows to decrease the

drive size of the source drive by increments of 1%.

T E C H N O L O G I E S

User Guide

1:11 HDD Duplicator PRO

(HDU11SITDR)

Technical Support

If you need any assistance to get your unit functioning properly, please have your

product information ready and contact Addonics Technical Support at:

Hours: 8:30 am - 6:00 pm PST

Phone: 408-453-6212

Email: http://www.addonics.com/support/query/

v6.1.11

ENT

ESC

Duplicator Panel

Source Drive Bay

Target Drive Bay 6 - 11

Target Drive Bay 1 - 5

Power Switch

1 2

Note: Make sure that the capacity of the target hard disk is equal or larger than the source hard disk. For example, on the label of the hard drives,

I. Installing Drive into the HDD DuplicatorFor installing a hard drive on the various enclosures that come with the HDD duplicator, refer to the bund

Pas de commentaire

Addonics Technologies HDU11SITDR Manuel d'utilisateur